This should play if your Web browser has WebAssembly enabled (most do). Most examples will play unless they need to load files. The first time you click Play, Csound will spend a few seconds loading, then play. You can edit this code and replay it.
<CsoundSynthesizer> <CsOptions> ; Select audio/midi flags here according to platform -odac ;;;realtime audio out ;-iadc ;;;uncomment -iadc if real audio input is needed too ; For Non-realtime ouput leave only the line below: ; -o partikkel.wav -W ;;; for file output any platform </CsOptions> <CsInstruments> ; Required settings for WebAudio: sr = 48000 ksmps = 128 nchnls = 2 nchnls_i = 1 ; sr = 44100 ; ksmps = 20 ; nchnls = 2 giSine ftgen 0, 0, 65537, 10, 1 giCosine ftgen 0, 0, 8193, 9, 1, 1, 90 instr 1 kgrainfreq = 200 ; 4 grains per second kdistribution = 0 ; periodic grain distribution idisttab = -1 ; (default) flat distribution used for grain distribution async = 0 ; no sync input kenv2amt = 0 ; no secondary enveloping ienv2tab = -1 ; default secondary envelope (flat) ienv_attack = -1 ; ; default attack envelope (flat) ienv_decay = -1 ; ; default decay envelope (flat) ksustain_amount = 0.5 ; time (in fraction of grain dur) at sustain level for each grain ka_d_ratio = 0.5 ; balance between attack and decay time kduration = (0.5/kgrainfreq)*1000 ; set grain duration relative to grain rate kamp = 5000 ; amp igainmasks = -1 ; (default) no gain masking kwavfreq = 440 ; fundamental frequency of source waveform ksweepshape = 0 ; shape of frequency sweep (0=no sweep) iwavfreqstarttab = -1 ; default frequency sweep start (value in table = 1, which give no frequency modification) iwavfreqendtab = -1 ; default frequency sweep end (value in table = 1, which give no frequency modification) awavfm = 0 ; no FM input ifmamptab = -1 ; default FM scaling (=1) kfmenv = -1 ; default FM envelope (flat) icosine = giCosine ; cosine ftable kTrainCps = kgrainfreq ; set trainlet cps equal to grain rate for single-cycle trainlet in each grain knumpartials = 3 ; number of partials in trainlet kchroma = 1 ; balance of partials in trainlet ichannelmasks = -1 ; (default) no channel masking, all grains to output 1 krandommask = 0 ; no random grain masking kwaveform1 = giSine ; source waveforms kwaveform2 = giSine ; kwaveform3 = giSine ; kwaveform4 = giSine ; iwaveamptab = -1 ; (default) equal mix of all 4 sourcve waveforms and no amp for trainlets asamplepos1 = 0 ; phase offset for reading source waveform asamplepos2 = 0 ; asamplepos3 = 0 ; asamplepos4 = 0 ; kwavekey1 = 1 ; original key for source waveform kwavekey2 = 1 ; kwavekey3 = 1 ; kwavekey4 = 1 ; imax_grains = 100 ; max grains per k period asig partikkel kgrainfreq, kdistribution, idisttab, async, kenv2amt, ienv2tab, \ ienv_attack, ienv_decay, ksustain_amount, ka_d_ratio, kduration, kamp, igainmasks, \ kwavfreq, ksweepshape, iwavfreqstarttab, iwavfreqendtab, awavfm, \ ifmamptab, kfmenv, icosine, kTrainCps, knumpartials, \ kchroma, ichannelmasks, krandommask, kwaveform1, kwaveform2, kwaveform3, kwaveform4, \ iwaveamptab, asamplepos1, asamplepos2, asamplepos3, asamplepos4, \ kwavekey1, kwavekey2, kwavekey3, kwavekey4, imax_grains outs asig, asig endin </CsInstruments> <CsScore> i1 0 5 ; partikkel e </CsScore> </CsoundSynthesizer>