foscil — A basic frequency modulated oscillator.
ifn -- function table number. Requires a wrap-around guard point.
iphs (optional, default=0) -- initial phase of waveform in table ifn, expressed as a fraction of a cycle (0 to 1). A negative value will cause phase initialization to be skipped. The default value is 0.
xamp -- the amplitude of the output signal.
kcps -- a common denominator, in cycles per second, for the carrier and modulating frequencies.
xcar -- a factor that, when multiplied by the kcps parameter, gives the carrier frequency.
xmod -- a factor that, when multiplied by the kcps parameter, gives the modulating frequency.
kndx -- the modulation index.
foscil is a composite unit that effectively banks two oscil opcodes in the familiar Chowning FM setup, wherein the audio-rate output of one generator is used to modulate the frequency input of another (the “carrier”). Effective carrier frequency = kcps * xcar, and modulating frequency = kcps * xmod. For integral values of xcar and xmod, the perceived fundamental will be the minimum positive value of kcps * (xcar - n * xmod), n = 0,1,2,... The input kndx is the index of modulation (usually time-varying and ranging 0 to 4 or so) which determines the spread of acoustic energy over the partial positions given by n = 0,1,2,.., etc. ifn should point to a stored sine wave. Previous to version 3.50, xcar and xmod could be k-rate only.
The actual formula used for this implementation of FM synthesis is xamp * cos(2π * t * kcps * xcar + kndx * sin(2π * t * kcps * xmod) - π), assuming that the table is a sine wave.
Here is an example of the foscil opcode. Play foscil.csd
Example 368. Example of the foscil opcode.
See the sections Real-time Audio and Command Line Flags for more information on using command line flags.
<CsoundSynthesizer> <CsOptions> ; Select audio/midi flags here according to platform -odac ;;;realtime audio out ;-iadc ;;;uncomment -iadc if realtime audio input is needed too ; For Non-realtime ouput leave only the line below: ; -o foscil.wav -W ;;; for file output any platform </CsOptions> <CsInstruments> sr = 44100 ksmps = 32 nchnls = 2 0dbfs = 1 instr 1 kcps = 440 kcar = 1 kmod = p4 kndx line 0, p3, 20 ;intensivy sidebands asig foscil .5, kcps, kcar, kmod, kndx, 1 outs asig, asig endin </CsInstruments> <CsScore> ; sine f 1 0 16384 10 1 i 1 0 9 .01 ;vibrato i 1 10 . 1 i 1 20 . 1.414 ;gong-ish i 1 30 5 2.05 ;with "beat" e </CsScore> </CsoundSynthesizer>
More information about frequency modulation on Wikipedia: http://en.wikipedia.org/wiki/Frequency_modulation_synthesis