Description

Accesses table values by direct indexing with linear interpolation.

Syntax

ares tablei andx, ifn [, ixmode] [, ixoff] [, iwrap]

ires tablei indx, ifn [, ixmode] [, ixoff] [, iwrap]

kres tablei kndx, ifn [, ixmode] [, ixoff] [, iwrap]

Initialization

ifn -- function table number. tablei requires the extended guard point.

ixmode (optional) -- index data mode. The default value is 0.

ixoff (optional) -- amount by which index is to be offset. For a table with origin at center, use tablesize/2 (raw) or .5 (normalized). The default value is 0.

iwrap (optional) -- wraparound index flag. The default value is 0.

Performance

tablei is a interpolating unit in which the fractional part of index is used to interpolate between adjacent table entries. The smoothness gained by interpolation is at some small cost in execution time (see also oscili, etc.), but the interpolating and non-interpolating units are otherwise interchangeable. Note that when tablei uses a periodic index whose modulo n is less than the power of 2 table length, the interpolation process requires that there be an (n + 1)th table value that is a repeat of the 1st (see f Statement in score).

	Warning
	Reading tables which contain stereo- or multichannel-information probably causes unwanted noise as the opcode interpolates between subsequent positions of the table regardless of the origin of its content. Usually just the content of one channel is expected Consider using loscilx instead. b

Examples

Here is an example of the tablei opcode. Play tablei.csd

<CsoundSynthesizer>
<CsOptions>
; Select audio/midi flags here according to platform
-odac     ;;;realtime audio out
;-iadc    ;;;uncomment -iadc if realtime audio input is needed too
; For Non-realtime ouput leave only the line below:
; -o tablei.wav -W ;;; for file output any platform
</CsOptions>
<CsInstruments>

sr = 44100
ksmps = 32
nchnls = 2
0dbfs  = 1

seed 0	;generate new values every time the instr is played

instr 1

ifn = p4
isize = p5
ithresh = 0.5
    
itemp ftgen ifn, 0, isize, 21, 2

iwrite_value = 0
i_index = 0
    
loop_start:
    iread_value tablei i_index, ifn
    
    if iread_value > ithresh then
         iwrite_value = 1
    else
         iwrite_value = -1
    endif
tableiw iwrite_value, i_index, ifn
loop_lt i_index, 1, isize, loop_start        
    turnoff

endin

instr 2

ifn = p4
isize = ftlen(ifn)    
prints "Index\tValue\n"
    
i_index = 0
loop_start:
    ivalue tablei i_index, ifn
    prints "%d:\t%f\n", i_index, ivalue

  loop_lt i_index, 1, isize, loop_start		;read table 1 with our index

aout oscili .5, 100, ifn			;use table to play the polypulse
     outs   aout, aout

endin
</CsInstruments>
<CsScore>
i 1 0 1 100 16
i 2 0 2 100
e
</CsScore>
</CsoundSynthesizer>

See Also

table, table3, oscil1, oscil1i, osciln

More information on this opcode: http://www.csoundjournal.com/issue12/genInstruments.html , written by Jacob Joaquin